RaceAir Boost Dual

Keep your visor from fogging up and the dust out of your helmet! Perfect fit for your SxS, short course ripper, or full blown spec truck. Complete with wiring harness, rocker switch and hoses this is your one-stop shop for clean, fresh air in your helmet! The RaceAir billet housing includes specific roll bar sizes available to fit your vehicle. You also have the option of the remote speed control for your dash to keep the power right at your fingertips.

• Variable Speed Control
• Optional remote control with 10ft cable
• Lightweight, durable billet housing
• Brushless, DC Motor
• Option of Panel Mount Plate or Roll Bar mounts included for Maverick R, Speed UTV, 1.25"/2", 1.5"/1.75" or 1.85"/2.5". Rotate the bracket 90 degrees to change between the two bar sizes
• Two Air Outlets
• Can be mounted in any direction. (Sideways, upside down)

Looking for a race focused unit? Check out the RaceAir Pro here!

Cleaning Instructions:

• • Step 1: Tap the filter to remove any loose dirt. Apply 409 or simple green works great.   Let stand for 10–15 minutes and allow the cleaner to break down the dirt.
  • Step 2: Rinse with tap water or a garden hose from the inside out. Do not use high pressure.
  • Step 3: Let it air dry out of direct sunlight. Do not apply heat. Wait until the filter is completely dry.

• RaceAir Boost Dual
• Variable Speed Controller either on the unit or on a 10ft remote
• Selectable mounting bracket with hardware
• <1 Micron Filter and Prefilter

• 3200-3600 CFM depending on the length of hose 
• 2.8 - 4 amps (5amp fuse recommended)
• 2.1 lbs with bracket and controller
• 2-year manufacturer defect warranty

UTV Roll Bar Sizes
Rocker Switch Wiring Diagram